ParkZone VisionAire BNF Manual de instrucciones

VisionAire ™Instruction Manual / Bedienungsanleitung Manuel d’utilisation / Manuale di Istruzioni

ENControl Direction TestTransmitter commandAircraft ReactionElevatorUp Elevator CommandDown Elevator CommandAileronStick RightStick LeftRudderStick Ri

ENAS3X Control Direction TestPerform the Control Direction Test to ensure the aircraft responds cor-rectly to your transmitter. Once you are sure the

ENAlways decrease throttle atpropeller strike.Range Check your Radio SystemConsult local laws and ordinances before choosing a fl ying location.Perform

ENDisassembly 1. Remove the screw (A) and spinner (B) from the collet (G). 2. Remove the spinner nut (C), propeller (D), backplate (E) and collet f

ENPlease see your local or regional modeling association’s guidelines for proper, safe operation of your model aircraft.Effective January 1, 2011A. GE

ENProblem Possible Cause SolutionAircraft will not re-spond to throttle but responds to other controlsThrottle not at idle and/or throttle trim too hi

ENWhat this Warranty CoversHorizon Hobby, Inc. (“Horizon”) warrants to the original purchaser that the product purchased (the “Product”) will be free

ENDeclaration of Conformity(in accordance with ISO/IEC 17050-1) No. HH2012092701Product(s): PKZ VisionAire BNF Item Number(s): PKZ6580Equipment

Country of Purchase Horizon Hobby Address Phone Number/Email AddressUnited States of AmericaSales4105 Fieldstone RdChampaign, Illinois 61822 USA800-3

Part # | NummerNuméro | CodiceDescription Beschreibung Description DescrizioneEFLB25003S302500mAh 3S 11.1V 30C LiPo, 12AWG EC3 by E-fl iteE-fl ite 2500m

ENEN• By handling, charging or using the included Li-Po battery, you assume all risks associated with lithium batteries. • If at any time the batter

© 2012 Horizon Hobby, Inc. ParkZone, VisionAire, AS3X, E-flite, Blade, Celectra, EC3, DSM, DSM2, DSMX, Bind-N-Fly, ModelMatch and SFG Technologyare t

ENENTo register your product online, visit www.parkzone.comWelcome to the exciting world of 3D fl ight! Even if this isn’t your fi rst 3D airplane, the

ENENWhen a Li-Po battery is discharged below 3V per cell, it will not hold a charge. The ESC protects the fl ight battery from over-discharge using Low

ENEN1. Press the latch button (A) and remove the battery hatch.2. Apply the included strip of hook and loop tape to the bottom of your battery.3.

EN1. Install the landing gear strut (A) with the wheels raked forward as shown.2. Install the cover (B) on the fuselage using 4 screws (C).Disasse

ENFly the model at recommended settings before making changes.The illustration shows linkage positions chosen for the most balanced aerobatic response

EN1. Slide the wing tube (A) into the fuselage.CAUTION: DO NOT crush or otherwise damage the wiring when attaching the wing to the fuselage.2. Ins

ENTransmitter SetupIMPORTANT: The AR635 receiver’s default setting is for 3D mode using the DX6i transmitter and above. If you choose to fl y using ano