ParkZone Ultra Micro T-28 Trojan RTF Manual de instrucciones

Ultra Micro T-28 Trojan RTF/BNFRTFInstruction ManualBedienungsanleitungManuel d’utilisationManuale di Istruzioni

10Before  rst  ight or in the event of an accident, check to make sure the  ight control surfaces are centered. It is much better to do this mecha

11Receiver Control Unit, Arming and Motor Control TestTurn on the transmitter before connecting the  ight battery to the aircraft. Binding is done by

12Propeller and Propeller Shaft MaintenanceCAUTION: DO NOT handle propeller parts while the  ight battery is connected. Personal injury could result.

13FlyingAlways avoid  ying near houses, trees, wires and buildings. You should also be careful to avoid  ying in areas where there are many people,

14Troubleshooting GuidePROBLEMPOSSIBLE CAUSE SOLUTIONAircraft will not respond to throttle but responds to other controls• Throttle not at idle at co

15Replacement Parts and Optional PartsNumber DescriptionPKZ10353.7V 120mAh Li-Po BatteryPKZ3240DC 3.7V Li-Po ChargerEFL9051130 x 70 Propeller with S

16 defective. In the event of a defect, these are the Purchaser’s exclusive remedies. Horizon reserves the right to inspect any and all equipment

17Declaration of ConformityCompliance Information for the European Union (in accordance with ISO/IEC 17050-1) No. HH2010072901Product(s): PKZ T-28

18Instructions for disposal of WEEE by users in the European UnionThis product must not be disposed of with other waste. Instead, it is the user’s re

19

2

© 2010 Horizon Hobby, Inc.ParkZone® products are distributed exclusively by Horizon Hobby, Inc. The Spektrum trademark is used with permission of Bach

3Safety Precautions and WarningsAs the user of this product, you are solely responsible for operating in a manner that does not endanger yourself and

4This exciting Ultra Micro Series edition of ParkZone’s wildly popular T-28 is a must-have for any intermediate to experienced pilot. Like the origina

5The Battery Charger (PKZ3240) included with the T-28 BNF has been designed to safely charge the Li-Po battery. You must read the following safety ins

6Charging the BatteryThe Battery Charging Process1. Charge only batteries that are cool to the touch and are not damaged. Look at the battery to make

7RTF®Binding is the process of programming the receiver of the control unit to recognize the GUID (Globally Unique Identi er) code of a single speci

8ElevatorTrimRudderTrimThrottleTrimAileronTrimThrottle/Aileron FunctionElevator/Rudder FunctionMode 1ThrottleTrimElevatorTrimAileronTrimElevator/Ailer

9AileronRudderControl Direction Test, continuedThe transmitter (MLP4DSM) included with the T-28 is the same transmitter included in other Ultra Micro