DH 98 Mosquito Mk VIInstruction Manual / Bedienungsanleitung Manuel d’utilisation / Manuale di Istruzioni
ENThe CG location is 73-83mm back from the leading edge of the wing. Install the recommended fl ight battery with the end of the battery against the fr
ENMove the controls on the transmitter to make sure the aircraft control surfaces move correctly and in the proper direction. After performing the Con
ENDual RatesYour DSM2/DSMX full range transmitter features dual rates to help you select the amount of travel that you want from the control surfaces.
EN1. Disconnect the fl ight battery from the ESC (Required for Safety and battery life).2. Power OFF the transmitter.3. Remove the fl ight battery fr
ENProblem Possible Cause SolutionAircraft will not re-spond to throttle but responds to other controlsThrottle not at lowest position or throttle trim
ENWhat this Warranty CoversHorizon Hobby, Inc. (“Horizon”) warrants to the original purchaser that the product purchased (the “Product”) will be free
ENRobert Peak Chief Financial Offi cerHorizon Hobby, Inc.Contact InformationDeclaration of Conformity(in accordance with ISO/IEC 17050-1) No. HH20131
Replacement Parts • Ersatzteile • Pièces de rechange • Pezzi di ricambioPart # | NummerNuméro | CodiceDescription Beschreibung Description Descrizione
Optional Parts • Optionale Bauteile • Pièces optionnelles • Pezzi opzionaliPart # | NummerNuméro | CodiceDescription Beschreibung Description Descrizi
© 2013 Horizon Hobby, Inc. ParkZone, E-flite, Celectra, EC3, DSM, DSM2, DSMX, DSMX logo, Z-Foam, the BNF logo, Plug-N-Playand ModelMatch are trademar
ENNOTICEAll instructions, warranties and other collateral documents are subject to change at the sole discretion of Horizon Hobby, Inc. For up-to-dat
ENTo register your product online, visit www.parkzone.comThis outstanding replica of the Mosquito Mk VI has been engineered to fl y every bit as good a
EN“Binding” is the process of programming the receiver to recognize the GUID (Globally Unique Identifi er) code of a single specifi c transmitter. You n
EN1. Turn the latch (A).2. Lift the back of the battery hatch and pull backwards to remove the battery hatch.3. Install the fully charged batter
EN1. Remove the tubes (A), inside struts with wheel collars (B) and screws (C) from the fi xed left and right struts. 2. Install the wheels (D), ins
ENWe recommend installing the Flaps (optional) in the wing before installing the wing on the fuselage.1. Carefully cut the tape over each fl ap servo
ENFactory SettingsHorns ArmsElevatorRudderAileronsFlapsControl Horn and Servo Arm Settings1. Turn the latch (A) and carefully remove the hatch (B) f
ENFixed Landing Gear Installation1. Attach each wheel (A) to a fi xed landing gear strut by using a wheel collar (B), outer strut (C), tube (D) and s
Comentarios a estos manuales