
EN
Turntheclevisonthelinkagetochangethelengthofthelinkage
betweentheservoarmandthecontrolhorn.
• Pullthetubefromtheclevistothelinkage.
• Carefullyspreadtheclevis,theninserttheclevispinintothe
desired hole in the control horn.
• Movethetubetoholdtheclevisontothecontrolhorn.
Afterbindingatransmittertothemodelreceiver,setthetrimsand
sub-trimsto0,thenadjusttheclevisestocenterthecontrolsurfaces.
Flythemodelatfactorysettingsbeforemakingchanges.Forpilotswho
wishformorecontrolthrow,adjustthepositionofthelinkagesontheservo
armsandcontrolhornsforincreasedtravel.
Horns
1. Slidethehorizontaltailtubeintotheholeinthe
rear of the fuselage.
2. Installtheleftandrighthorizontaltailsontothe
fuselageasshown.Ensurethecontrolhorn
facesdown.
3. Apply four pieces of tape to the fuselage mounts
(one on the top and bottom of each half of the
horizontaltail).
4. Attachtheclevistotheelevatorcontrolhorn
(seeinstructionsforclevisconnection).
5. Whenneeded,disassembleinreverseorder.
Intallation
1. Install the left landing gear door hinge ()
(markedL)inthewingclampasshown.
2. Install the left landing gear plate (A)(marked
withanL)inthewingusingfourscrews().
3. Install the left landing gear strut in the plate as
shown.
4. Installtheleftcover(C)(markedL)onthestrut
(D)usingtwoscrews(E).
5. Installthewheelonthestrutusingthecollar.
Makesurethebushingsideofthewheelis
towardthebendinthestrut.
6. Tightenthesetscrew(F)inthecollar.Usea
smallamountofthreadlocktoholdthesetscrew
in the collar.
7. Install the right landing gear the same as the
left landing gear.
Whenneeded,disassembleinreverseorder.
3X10mm(2)
3X15mm(4)
A
C
D
E
3X4mm(1)
F
Comentarios a estos manuales