ParkZone F4U-1A Corsair Manual de instrucciones Pagina 6

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 22
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 5
EN
1.Carefullyliftthebackofthecanopyhatch(A)andpullthehatchpinsfromthe
holesinthefuselagetoremovethecanopyhatch.
2.Installtheightbattery()allthewaytothefrontofthebatterycompartment.
3.ConnectthebatteryconnectortotheESCpowerconnector.
4.Makesuretheightbattery()issecureusingahookandloopstrap(C).
5. Install the battery hatch on the fuselage. Ensure the magnets on the hatch and
fuselage connect.
CAUTION:AlwaysdisconnecttheLi-Pobatteryfromtheaircraftreceiver
whennotyingtoavoidover-dischargingthebattery.Batteriesdischarged
toavoltagelowerthanthelowestapprovedvoltagemaybecome
damaged,resultinginlossofperformanceandpotentialrewhen
batteries are charged.
CAUTION: Alwayskeephandsawayfromthepropeller.Whenarmed,
themotorwillturnthepropellerinresponsetoanythrottlemovement.
BIND PLUG

1. Readthetransmitterinstructionsforbindingtoareceiver(locationoftransmitter’sBindcontrol).
2. Makesurethetransmitterispoweredoff.
3. Movethetransmittercontrolstoneutral(ightcontrols:rudder,elevatorsandailerons)ortolow
positions(throttle,throttletrim).*
4. Installabindpluginthereceiverbindport.
5. ConnecttheightbatterytotheESC.
6. ThereceiverLEDwillbegintoashrapidly.
7. Poweronthetransmitterwhileholdingthetransmitterbindbuttonorswitch.Refertoyour
transmitter’smanualforbindingbuttonorswitchinstructions.
8. Whenthereceiverbindstothetransmitter,thelightonthereceiverwillturnsolidandtheESC
willproduceaseriesofsounds.Onelongtone,thenthreeshorttonesconrmtheLVCissetfor
the ESC.
9. Removethebindplugfromthebindport.
10. Safelystorethebindplug(someownersattachthebindplugtotheirtransmitterusingtwo-part
loopsandclips).
11. Thereceivershouldretainthebindinginstructionsreceivedfromthetransmitteruntilanother
binding is done.
*Thethrottlewillnotarmifthetransmitter’sthrottlecontrolisnotputatthelowestposition.Ifyouencounterproblems,followthebindinginstructionsand
refertothetransmittertroubleshootingguideforotherinstructions.Ifneeded,contacttheappropriateHorizonProductSupportofce.
BindingistheprocessofprogrammingthereceiverofthecontrolunittorecognizetheGUID(GloballyUniqueIdentier)codeofasinglespecictransmitter.
Youneedto‘bind’yourchosenSpektrumDSM2/DSMXtechnologyequippedaircrafttransmittertothereceiverforproperoperation.
Pleasevisitwww.bindny.comforacompletelistofcompatibletransmitters.

CAUTION:WhenusingaFutabatransmitterwithaSpektrumDSMmodule,youmustreversethe
throttlechannelandrebind.RefertoyourSpektrummodulemanualforbindingandfailsafe
instructions.RefertoyourFutabatransmittermanualforinstructionsonreversingthethrottlechannel.
A
C

BIND/DATA
THRO
AILE
ELEV
RUDD
GEAR
AUX 1
2.4GHz DSM® TECHNOLOGY
6CH SPORT RECEIVER 2048
6
Vista de pagina 5
1 2 3 4 5 6 7 8 9 10 11 ... 21 22

Comentarios a estos manuales

Sin comentarios