Parkzone PKZ5980 Manual de usuario descargar pdf (Pagina 13)

Disassembly

1. Remove the screw (A) and spinner (B) from the collet (G).

2. Remove the spinner nut (C), propeller (D), spinner backplate (E), backplate

(F) and collet (G) from the motor shaft (H). You will need a tool to turn the

spinner nut.

3. Remove the 4 screws (I) from the motor mount (J) and the fuselage.

4. Disconnect the motor wires from the ESC wires.

5. Remove the 4 screws (K) and motor (L) from the motor mount.

Assembly

Assemble in reverse order.

Correctly align the wire the colors and connect the motor to the ESC. The

propeller side with the numbers for diameter and pitch (for example, 10 X 8)

should face rearward, toward the motor. The grips on the propeller will also

face rearward, toward the motor. Use a tool to tighten the spinner nut on

the propeller.

Not all wiring shown.

AB E

High Rate Low Rate

Aileron 40mm up/30 down 26mm up/24down

Elevator 20mm up/down 15mm up/down

Rudder 40mm left/right 30mm left/right

Your DSM2/DSMX full range transmitter features dual rates to help you select

the amount of travel that you want from the control surfaces.

FG H

3 X 15mm (4)

3 X 8mm (4)

The ailerons are factory pre-set to allow for more up travel than

down (differential).

Dual Rates

Service of Power Components

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20 21

Sin comentarios

Parkzone PKZ5980 Manual de usuario Pagina 13