Parkzone PKZ5980 Manual de usuario descargar pdf (Pagina 7)

Assembling Landing Gear

1. Install the left and right (marked L and R) landing

gear covers (A) on the axle assembly (B) using

left and right simulated shock absorbers (C)

(marked L and R) and 4 screws (D).

2. Install a spacer (F) and wheel (G) on each end of

the axle using a wheel collar (H) and

setscrew (I).

Tip: Use a small amount of threadlock on the screw

of the wheel collar to ensure the wheel is secured

to the axle.

Attaching Landing Gear

1. Turn the fuselage so that the bottom of the wing

faces up.

2. Carefully install the front, then the rear of the

assembled landing gear (J) in the fuselage slots.

It takes a small amount of force to spread the

landing gear enough to insert it into the fuselage

slots.

3. Install the left and right, back and front (marked

LB, RB, LF and LB) plates (K) over the fuselage

slots using 8 screws (L).

4. Where needed, disassemble in reverse order,

carefully spread the landing gear wires to

remove the assembly from the fuselage.

2.5 X 8mm (8)

3 X 4mm (2)

1.5 X 6mm (4)

Installing Landing Gear

1 2 3 4 5 6 7 8 9 10 11 12 ... 20 21

Sin comentarios

Parkzone PKZ5980 Manual de usuario Pagina 7